Xylem IM253 R0 AquaStart Combination Soft Starters User Manual

AquaStart™COMBINATION SOFT STARTERS START-UP MANUALINSTRUCTION MANUALIM253 R0

10PROGRAMMING VIA DIP SWITCHES AND TRIM POTS:To program DI2 for 3-wire control, refer to Figure 5 and perform the following:1. Press and hold the rese

11PARAMETERS EXAMPLE (Optional Keypad) (P219 = 1):Soft Starter Data (Example):Enclosure Model: AST40150SSW-07 Model: SSW07XY0024T5SZMotor Data (Exam

12TRIM-POT AND DIP SWITCH SETTINGS (P219 = 0):Soft Starters are shipped with factory default values. If Trim-Pots and Dip Switches have been changed,

13U100 %Timefixed voltagecurrent limitreached set levelof current limitAccel TimeCURRENT LIMITING FOR LOADS WITH HIGH OR CONSTANT STARTING TORQUE:Curr

14SOFT STARTER OPERATION:The Soft Starter is now ready to operate via the 2-Wire or 3-Wire Control that was set up in the previous steps. To start the

15NOTES

CentriPro and AquaStart are trademarks of Xylem Inc. or one of its subsidiaries. © 2013 Xylem Inc. IM253 Rev. 0 September 2013Xylem Inc.2881 Eas

2Power Connections ...

3POWER CONNECTIONSThe AquaStart Start-up Manual is a supplement to help get the AquaStart commissioned quickly using the most common installation and

4BASIC WIRING1. Mount the AquaStart panel to a at vertical surface.2. Connect the three-phase incoming power leads to the R, S, and T connections on

5START-UP BY VOLTAGE RAMP USING THE KEYPAD: (most common conguration) 1. The soft starter should be powered up with a display of “RDY”. 2. Press th

6LOCAL/REMOTE MODES (Optional Keypad):In the previous section the soft starter was operated from the keypad (Local Mode). Note the green local indicat

7CONTROL WIRING TERMINALSCONNECTIONS FOR REMOTE START/STOP* Emergency StopA Safety or Emergency Stop function can be implemented by removing the J1 ju

8CONNECTIONS FOR REMOTE START/STOP** Remote Start/StopA Remote Start/Stop function can be implemented to allow control of the soft starter by an exter

9CONNECTIONS FOR REMOTE CONTROL OF THE SSW07 WHEN PURCHASED SEPARATELYCONTROL VIA 2-WIRE START/STOP (Remote Mode):FIGURE 5 – Control via 2-wire Start